New Course in Line for Corrosion Mapping

By Decibel -

New BINDT approved PCN Level 2 courses for Corrosion mapping will be launching this February at our Sheffield Training Centre and extending to remaining global locations.

Interested participants may book their sets 

Popular posts from this blog

What is the Plate Lamination Defect?

By Decibel -
Image
Plate lamination defect is one of the primary processing discontinuity that originates during hot or cold forming processes and is considered as a serious metal plate defect.  All the metals contain discontinuities at micro and macro levels. These discontinuities, when above the acceptance level, are termed as defects. The discontinuities in metal are classified according to the stage of manufacturing in which they initiate.  Plate lamination defect can be defined as flat and thin subsurface separations present inside metal plate, parallel to the surface of the plates. The sources of this defect are inherent discontinuities present in metal such as inclusion and porosity, which are flattened during the rolling process.  Carbon Steel Plate Lamination Defect & Reasons A carbon steel plate is produced by the process of hot or cold rolling a thick slab. During this process, carbon steel may pass through the rollers many times to achieve the desired thickness. Each pass results in
Read more

Tired of Removing Paint to Inspect Welds?

By Decibel -
Image
Removing Paint is Time Consuming and Expensive For decades, legacy NDT methods, such as penetrant and magnetic particle inspection, required that paint be removed from parts before they could be inspected. The paint was often removed using harsh chemicals. Over time, increasingly strict government regulations about chemical safety and waste treatment have caused the cost of paint removal to rise dramatically. As the cost of paint removal increases so does the overall cost of inspection. Inspect Through Paint with Dynamic Lift-Off Compensation Technology The use of a flexible PCB probe with cross-wound coil technology combined with dynamic lift-off compensation makes it possible to detect surface-breaking cracks through paint, resulting in significant time and cost savings. The principle of dynamic lift-off compensation.   Our  MagnaFORM™ probe  features dynamic lift-off compensation and helps make weld inspection fast and efficient. The dynamic lift-off compensation helps the p
Read more

Immediate Requirement for Multi Discipline NDT Technicians

By Decibel -
Immediate Requirement for Multi Discipline NDT Technicians Exp:  5 - 10 yrs.   | Opening(s):  30 JOB DESCRIPTION  Review the job packs and understand the   NDT  requirements specified. - Keep all stationary Equipment instruments/ Tools in good and calibrated condition. - Coordinate with  NDT  coordinator and the stationary equipment Inspector for carrying out  NDT activities.  - Prepare detailed reports and submit to the coordinator. Desired Candidate Profile - Minimum work experience of five (05) years in multi discipline  NDT  in a Petrochemical, Oil & Gas plant. - Work experience of turnaround inspections of Columns, Vessels, Exchangers, Tanks, Piping etc. - Experience in reading and understanding procedures, specifications, codes and standards related to NDE and area of work. - Experience in writing, reporting and record keeping the detailed technical reports related to NDE. - Working experience in Shutdown and turnaround will be preferred. - Typical plant exper
Read more