CSWIP Preparatory Course in Kerala for just 10000/-

By Decibel -
Decibel offers the Cswip preparatory courses for just Rs:10000/- for 3.1

Most successful batch results in Kerala.

Yearly an overall pass rate of 90% in Kerala for Decibel trained students and good placement supports for career progression.

100% pass result for CQC candidates whom had attended the CSWIP 3.1 classes.

Global Training Modules....

It's not just exam training it's experiencing to become a welding inspector at Decibel. 


Feel the difference in Training Quality from a true global trainers. 

Faculty members are experienced in Examjnation panel of TWI. 

 







Popular posts from this blog

What is the Plate Lamination Defect?

By Decibel -
Image
Plate lamination defect is one of the primary processing discontinuity that originates during hot or cold forming processes and is considered as a serious metal plate defect. All the metals contain discontinuities at micro and macro levels. These discontinuities, when above the acceptance level, are termed as defects. The discontinuities in metal are classified according to the stage of manufacturing in which they initiate. Plate lamination defect can be defined as flat and thin subsurface separations present inside metal plate, parallel to the surface of the plates. The sources of this defect are inherent discontinuities present in metal such as inclusion and porosity, which are flattened during the rolling process. Carbon Steel Plate Lamination Defect & ReasonsA carbon steel plate is produced by the process of hot or cold rolling a thick slab. During this process, carbon steel may pass through the rollers many times to achieve the desired thickness.Each pass results in an increa…
Read more

Comparison of the use of rutile and cellulosic electrodes Knowledge Sharing From Decibel.

By Decibel -
Image
Comparison of the use of rutile and cellulosic electrodes Types of electrodes and their compositions Many types of manual metal arc (MMA) electrodes are available on the market. Depending on the main constituent of their flux, they are grouped into three categories: cellulosic, rutile and basic. All electrodes consist of a cored wire (typically 2.5–6mm diameter) coated by a flux. The core wire is generally made of low-quality riming steel and the fluxes contain many elements allowing refinement of the weld macrostructure. The composition of the flux impacts the electrodes’ behaviour. The main constituents of the different types of electrodes and the shielding gas created for each are described in Table 1 (Bowniszewski, 1979). Table 1 Main constituent of the three possible types of electrodes and shielding gas created by its combustion. Electrode typeMain constituentShielding gas createdRutileTitania (TiO2)Mainly CO2BasicCalcium compoundsMainly CO2CellulosicCelluloseHydrogen + CO2
MMA e…
Read more

Tired of Removing Paint to Inspect Welds?

By Decibel -
Image
Removing Paint is Time Consuming and ExpensiveFor decades, legacy NDT methods, such as penetrant and magnetic particle inspection, required that paint be removed from parts before they could be inspected. The paint was often removed using harsh chemicals. Over time, increasingly strict government regulations about chemical safety and waste treatment have caused the cost of paint removal to rise dramatically. As the cost of paint removal increases so does the overall cost of inspection.Inspect Through Paint with Dynamic Lift-Off Compensation TechnologyThe use of a flexible PCB probe with cross-wound coil technology combined with dynamic lift-off compensation makes it possible to detect surface-breaking cracks through paint, resulting in significant time and cost savings.The principle of dynamic lift-off compensation.
Our MagnaFORM™ probe features dynamic lift-off compensation and helps make weld inspection fast and efficient. The dynamic lift-off compensation helps the probe maintain se…
Read more